Specifying the Interface to Handle Traffic for a CCC
To configure the VLAN-bundled logical interface as the interface to handle traffic for
a circuit connected to the Layer 2 VPN routing instance, include the following
statements:
You can include the statements at the same hierarchy level at which you include the
instance-type l2vpn
To enable a Layer 2 VPN routing instance on a PE router, include the
For more information, see the JUNOS VPNs Configuration Guide.
The
the customer edge (CE) router. If the Layer 2 VPN routing instance is being connected
to a single-tag Layer 2 circuit, specify
2 VPN routing instance is being connected to a dual-tag Layer 2 circuit, specify
ethernet-vlan
To specify the interface to handle traffic for a circuit connected to the Layer 2 VPN
routing instance, include the
interface.
Configuring a Layer 2 Circuit on a VLAN-Bundled Logical Interface
This topic describes how to configure a Layer 2 circuit on a logical interface bound
to a list of VLAN IDs.
protocols {
l2vpn {
(control-word | no-control-word);
encapsulation-type (ethernet | ethernet-vlan);
site site-name {
site-identifier identifier;
interface logical-interface-name { # VLAN-bundled logical interface
. . . interface-options . . .
}
}
}
}
and
interface logical-interface-name
[edit routing-instances routing-instance-name]
[edit logical-systems logical-system-name routing-instances routing-instance-name]
encapsulation-type
statement specifies the Layer 2 protocol used for traffic from
as the encapsulation type.
Configuring a VLAN-Bundled Logical Interface on page 636
Specifying the Interface to Handle Traffic for a CCC Connected to the Layer 2
Circuit on page 636
Chapter 34: Configuring 802.1Q VLANs
as the encapsulation type. If the Layer
ethernet
statement and specify the VLAN-bundled logical
interface
Specifying the Interface to Handle Traffic for a CCC
statements:
l2vpn
statement.
635
Need help?
Do you have a question about the JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 and is the answer not in the manual?