Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 837

CCMs sent
CCMs received out of sequence
LBMs sent
Valid in-order LBRs received
Valid out-of-order LBRs received
LBRs received with corrupted data
LBRs sent
LTMs sent
LTMs received
LTRs sent
LTRs received
Sequence number of next LTM request
1DMs sent
Valid 1DMs received
Invalid 1DMs received
DMMs sent
DMRs sent
Valid DMRs received
Invalid DMRs received
Remote MEP count: 1
Identifier
201 00:90:69:0a:43:94
NOTE: You can use these same commands—
connectivity-fault-management mep-database
connectivity-fault-management interfaces
the CFM database information (which includes any ETH-DM frame counts) for receiver
MEP .
201
At router MX-PE1 , which contains the receiver MEP, you can use two different
6.
show oam ethernet connectivity-fault-management
statistics and ETH-DM frame counts.
To display only the delay statistics, use the
oam ethernet connectivity-fault-management
user@MX-PE1> show oam ethernet connectivity-fault-management
delay-statistics maintenance-domain md6
MEP identifier: 201, MAC address: 00:90:69:0a:43:94
Remote MEP count: 1
Remote MAC address: 00:90:69:0a:48:57
Delay measurement statistics:
Index One-way delay
(usec)
1 370
2 357
3 344
4 332
5 319
6 306
7 294
8 281
9 269
10 255
Chapter 44: Configuring ITU-T Y.1731 Ethernet Service OAM
MAC address State
ok
show oam ethernet
and
show oam ethernet
( detail | extensive
commands to display ETH-DM
delay-statistics
command:
Two-way delay
(usec)
Example: One-Way Ethernet Frame Delay Measurement
: 1590
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 10
: 0
: 0
: 0
: 0
: 0
: 0
Interface
ge-0/2/5.0
)—at router MX-PE1 to display
form of the show
767