Table of Contents
Advertisement
JUNOS 10.1 Network Interfaces Configuration Guide
Configuring an Unpartitioned SDH (VC-4-4C) Interface on a Channelized OC12/STM4 IQE
PIC
On a Channelized OC12 IQE PIC, you can configure one SDH (VC-4-4C) interface.
To configure an SDH (VC-4-4C) interface, include the
statements at the
This configuration creates interface
Example: Configuring an Unpartitioned SDH (VC-4-4C) Interface
Configure an unpartitioned SDH (VC-4-4C) interface, using partition 1 and
OC slices 4 through 6:
This configuration creates the interface
Configuring SDH (VC-4) Interfaces on Channelized OC12/STM4 IQE PICs
To configure an SDH (VC-4) interface on a Channelized OC12 IQE PIC, include the
partition
cstm4-fpc/pic/port]
This configuration creates interface
The partition number is the sublevel interface partition index and is correlated with
the channel number. For Channelized OC12 IQE PICs, the OC-slice range can be
from 1 through 12.
NOTE: For channelized OC12 IQE interfaces, channel numbering begins with 1 (:1).
The OC-slice range is the range of SONET/SDH slices. For SDH interfaces, the OC-slice
range specifies the bandwidth size required for the interface type you are configuring.
SDH (VC-4) interfaces must occupy three consecutive OC slices per interface, in one
of the following forms:
444
Configuring Channelized OC12/STM4 IQE Interfaces (SDH Mode)
[edit interfaces cstm4-fpc/pic/port]
[edit interfaces cstm4-fpc/pic/port]
no-partition interface-type so;
[edit interfaces cstm4-0/2/0]
no-partition interface-type so;
,
, and
oc-slice
interface-type
hierarchy level, specifying the
[edit interfaces cstm4-fpc/pic/port]
partition partition-number oc-slice oc-slice-range interface-type so;
1–3
4–6
7–9
10–12
no-partition
hierarchy level:
so-fpc/pic/port
.
so-0/2/0
.
statements at the
[edit interfaces
so
interface type:
.
so-fpc/pic/port:channel
and
interface-type
Advertisement
Table of Contents
