Control-Channel; Control-Polarity - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

control-channel

control-channel channel-name {
Syntax
}
[edit protocols protection-group ethernet-ring name (east-interface | west-interface)]
Hierarchy Level
Statement introduced in JUNOS Release 9.4.
Release Information
Configure the Ethernet RPS control channel logical interface to carry the RAPS PDU.
Description
The related physical interface is the physical ring port.
vlan vlan-id
Options
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics

control-polarity

control-polarity (negative | positive);
Syntax
[edit interfaces interface-name serial-options]
Hierarchy Level
Statement introduced before JUNOS Release 7.4.
Release Information
For X.21 interfaces only, configure the control signal polarity.
Description
Options positive
negative
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
vlan vlan-id;
—If the control channel logical interface is a trunk port, then a dedicated
defines the dedicated VLAN channel to carry the RAPS traffic. Only
vlan vlan-id
configure the vlan-id when the control channel logical interface is the trunk port.
Ethernet Ring Protection Switching Overview on page 851
—Positive signal polarity.
—Negative signal polarity.
Default:
positive
Configuring Serial Signal Polarities on page 281
Chapter 62: Summary of Interface Configuration Statements
control-channel
1039