Configuring An Atm1 Cell-Relay Circuit; Example: Configuring An Atm1 Cell-Relay Circuit - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
Table 30: ATM Logical Interface Encapsulation Types (continued)
Encapsulation Types
PPP over AAL5 LLC
PPP over AAL5 multiplex

Configuring an ATM1 Cell-Relay Circuit

For ATM1 interfaces, you can create an ATM cell-relay circuit by configuring an entire
ATM physical device or an individual VC. When you configure an entire device, only
cell-relay encapsulation is allowed on the logical interfaces; for ATM1 PICs, you use
the
of allowed VCs on both ingress and egress ATM interfaces should be the same. For
most interfaces, you can define a maximum of 4090 VCs per interface. The
highest-numbered VC value you can configure is 4089. Promiscuous mode removes
these limits. For more information, see "Configuring ATM Cell-Relay Promiscuous
Mode" on page 304.
For ATM1 interfaces, if you are dedicating the entire device to a cell-relay circuit,
include the
You can include this statement at the following hierarchy levels:
Once you include this statement, you cannot configure other logical interfaces in the
same physical interface.
NOTE: When you use ATM CCC cell-relay encapsulation, you must configure the
logical encapsulation as
encapsulation types on an interface that you have configured with ATM CCC cell-relay
physical encapsulation.

Example: Configuring an ATM1 Cell-Relay Circuit

Configure an ATM1 cell-relay circuit:
340
Configuring an ATM1 Cell-Relay Circuit
Comments
This encapsulation type is for ATM2 IQ interfaces only.
When you use this encapsulation type, you cannot configure point-to-multipoint
interfaces.
This encapsulation type is for ATM2 IQ interfaces only.
When you use this encapsulation type, you cannot configure point-to-multipoint
interfaces.
statement to control the number and location of VCs. The configuration
atm-options
allow-any-vci statement in the configuration of
allow-any-vci;
[edit interfaces interface-name unit 0]
[edit logical-systems logical-system-name interfaces interface-name unit 0]
atm-ccc-cell-relay
[edit interfaces at-1/2/0]
encapsulation atm-ccc-cell-relay;
unit 0 :
. You cannot mix different logical