Configuring The 10-Gigabit Ethernet Dwdm Interface Wavelength; 10-Gigabit Ethernet Dwdm Interface Wavelength Overview - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

Chapter 53
Configuring the 10-Gigabit Ethernet
DWDM Interface Wavelength

10-Gigabit Ethernet DWDM Interface Wavelength Overview

Configuring the 10-Gigabit Ethernet DWDM Interface Wavelength

10-Gigabit Ethernet DWDM Interface Wavelength Overview on page 815
Configuring the 10-Gigabit Ethernet DWDM Interface Wavelength on page 815
For M320, M120, T320, and T640 routers, the 10-Gigabit Ethernet DWDM PIC enables
you to configure 10-Gigabit Ethernet DWDM interfaces with full C-band International
Telecommunication Union (ITU)-Grid tunable optics, as defined in the following
specifications:
Intel TXN13600 Optical Transceiver I2C Interface and Customer EEPROM Preliminary
Specification, July 2004.
I2C Reference Document for 300 Pin MSA 10G and 40G Transponder, Edition 4,
August 04, 2003.
By default, the wavelength is 1550.12 nanometers (nm), which corresponds to 193.40
terahertz (THz).
To configure the wavelength on a 10-Gigabit Ethernet DWDM interface, include the
statement at the [edit interfaces ge-fpc/pic/port optics-options] hierarchy
wavelength
level:
[edit interfaces ge-0/0/0 optics-options]
wavelength nm;
For interface diagnostics, you can issue the show interfaces diagnostics optics ge-fpc/pic
operational mode command.
/port
Table 81 on page 816 shows configurable wavelengths and the corresponding
frequency for each configurable wavelength.
10-Gigabit Ethernet DWDM Interface Wavelength Overview
815