Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 471

Table 37: Clocking Capabilities by Channelized PIC Type (continued)
PIC Type SONET/SDH Level
Channelized The
clocking
STM1 IQ or IQE
supported at the
cstm1-fpc/pic/port]
level.
The
clocking
if you include it at the
interfaces
cau4-fpc/pic/port:channel]
interfaces so-fpc/pic/port]
hierarchy level.
Channelized The
clocking
STM4 IQ or IQE
supported at the
cstm4-fpc/pic/port]
level.
The
clocking
if you include it at the
interfaces
cau4-fpc/pic/port:channel]
interfaces so-fpc/pic/port]
hierarchy level.
Channelized The
clocking
STM16 IQE
supported at the
cstm16-fpc/pic/port]
level.
The
clocking
if you include it at the
interfaces
cau4-fpc/pic/port:channel]
interfaces so-fpc/pic/port]
hierarchy level.
Channelized E1 and T1 PIM Properties
Channelized E1 and T1 PIMs on J Series routers provide support for ISDN Primary
Rate Interface (PRI) connectivity for dial-in and callback and for use as primary or
backup network connections. You can configure up to 30 channelized E1 time slots
(
group, with the 16th E1 time slot or the 24th T1 time slot operating as the D-channel
to control the group of time slots as B-channels. These B-channels can operate
unconfigured. The encapsulation type
under the dialer interface.
For more information about configuring the dialer interface, see "Configuring ISDN
Logical Interface Properties" on page 875.
DS3 Level
statement is Not applicable.
[edit interfaces
hierarchy
statement is ignored
[edit
or
[edit
statement is Not applicable.
[edit interfaces
hierarchy
statement is ignored
[edit
or
[edit
statement is Not applicable.
[edit interfaces
hierarchy
statement is ignored
[edit
or
[edit
) or 23 channelized T1 time slots (
ce1-pim/0/port
Chapter 17: Channelized Interfaces
DS1/E1 Level
For E1 and NxDS0 channels, the
clocking statement is supported at
the
[edit interfaces
ce1-fpc/pic/port[1-63]]
level.
The
clocking
if you include it at the
interfaces e1-fpc/pic/port]
hierarchy level.
For E1 and NxDS0 channels, the
clocking statement is supported at
the
[edit interfaces
ce1-fpc/pic/port[1-4]:[1-63]]
hierarchy level.
The
clocking
if you include it at the
interfaces e1-fpc/pic/port]
hierarchy level.
For E1 and NxDS0 channels, the
clocking statement is supported at
the
[edit interfaces
ce1-fpc/pic/port[1-16]:[1-63]]
hierarchy level.
The
clocking
if you include it at the
interfaces e1-fpc/pic/port]
hierarchy level.
ct1-pim/0/port)
multilink-ppp , cisco-hdlc , or
Channelized E1 and T1 PIM Properties
hierarchy
statement is ignored
[edit
statement is ignored
[edit
statement is ignored
[edit
as an ISDN PRI
ppp is configured
401