Interface Status Tlv; Table 71: Interface Status Tlv Format - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
Displaying the Transmitted Port Status TLV
The JUNOS Software saves the last transmitted Port Status TLV from a local MEP. If
the transmission of the Port Status TLV has not been enabled, then the
displays "none." You can display the last saved transmitted Port Status TLV using
the
identifier maintenance-association identifier local-mep identifier remote-mep identifier
command, as in the following example:
user@host> show oam ethernet connectivity-fault-management mep-database
maintenance-domain md5 maintenance-association ma5 local-mep 2001 remote-mep 1001
Maintenance domain name: md5, Format: string, Level: 5

Interface Status TLV

The Interface Status TLV indicates the status of the interface on which the MEP
transmitting the CCM is configured, or the next-lower interface in the IETF RFC 2863
IF-MIB. The format of this TLV is shown in Table 71 on page 728. The enumerated
values are shown in Table 72 on page 729.

Table 71: Interface Status TLV Format

Parameter
Type = 4
Length
Value (See Table 72 on page 729)
728
Configuring Port Status TLV and Interface Status TLV
Remote MEP identifier: 1001, State: ok
MAC address: 00:19:e2:b0:74:00, Type: Learned
Interface: ge-2/0/0.0
Last flapped: Never
Remote defect indication: false
Port status TLV: none # RX PORT STATUS
Interface status TLV: none
show oam ethernet connectivity-fault-management mep-database maintenance-domain
Maintenance association name: ma5, Format: string
Continuity-check status: enabled, Interval: 100ms, Loss-threshold: 3 frames
MEP identifier: 2001, Direction: down, MAC address: 00:19:e2:b2:81:4a
Auto-discovery: enabled, Priority: 0
Interface status TLV: up, Port status TLV: up # TX PORT STATUS
Interface name: ge-2/0/0.0, Interface status: Active, Link status: Up
Remote MEP identifier: 1001, State: ok
MAC address: 00:19:e2:b0:74:00, Type: Learned
Interface: ge-2/0/0.0
Last flapped: Never
Remote defect indication: false
Port status TLV: none
Interface status TLV: none
Octet (Sequence)
1
2–3
4
command
show