This configuration creates the interfaces
ct1-fpc/pic/port:channel
NOTE: Class-of-service (CoS) rules cannot be applied to an individual channel
configured on channelized IQ interfaces. You can only apply CoS rules to the aggregate
bit streams.
Example: Configuring T1 or Channelized T1 Interfaces Under Channelized
T3 Interfaces
Configure T1 or channelized T1 interfaces, using partition 3 and partition 4:
This configuration creates interfaces
Configuring NxDS0 Interfaces on Channelized OC12/STM4 IQ PICs
Configure channelized NxDS0 IQ interfaces on the channelized T1 IQ interface by
including the
ct1-fpc/pic/port:channel]
This configuration creates the interface
The time-slot range is from 1 through 24. You can designate any combination of
time slots. To configure ranges, use hyphens. To configure discontinuous time slots,
use commas. You can use a combination of ranges and discontinuous time slots:
Example: Configuring NxDS0 Interfaces
Configure channelized NxDS0 interfaces, using partition 4 and time slots 1 through
10:
ct3-fpc/pic/port {
partition partition-number interface-type t1;
}
ct3-fpc/pic/port {
partition partition-number interface-type ct1;
}
.
[edit interfaces]
ct3-0/2/0:1:2 {
partition 3 interface-type t1;
}
ct3-0/2/0:1:2 {
partition 4 interface-type ct1;
}
,
partition
timeslots
hierarchy level, specifying the
[edit interfaces ct1-fpc/pic/port:channel:channel]
partition partition-number timeslots time-slot-range interface-type ds;
1,9-18,21
Configuring Channelized OC12/STM4 IQ Interfaces (SDH Mode)
Chapter 19: Configuring Channelized OC12/STM4 Interfaces
t1-fpc/pic/port:channel
t1-0/2/0:1:2:3
and
ct1-0/2/0:1:2:4
, and
statements at the
interface-type
ds
ds-fpc/pic/port:channel
and
.
[edit interfaces
interface type:
.
453