Dcd-Polarity; Dce - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

dcd-polarity

dcd-polarity (negative | positive);
Syntax
[edit interfaces interface-name serial-options]
Hierarchy Level
Statement introduced before JUNOS Release 7.4.
Release Information
Configure DCD signal polarity.
Description
Options positive
negative
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics

dce

dce;
Syntax
[edit interfaces interface-name],
Hierarchy Level
[edit interfaces interface-name serial-options clocking-mode]
Statement introduced before JUNOS Release 7.4.
Release Information
For Frame Relay only, respond to status enquiry message keepalives.
Description
When you configure the router to be a DCE, keepalives are disabled by default.
The router operates in DTE mode.
Default
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
—Positive signal polarity.
—Negative signal polarity.
Default:
positive
Configuring Serial Signal Polarities on page 281
Configuring the Router as a DCE with Frame Relay Encapsulation on page 388
Chapter 62: Summary of Interface Configuration Statements
1049
dcd-polarity