Caller - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

caller

caller (caller-id | accept-all);
Syntax
Hierarchy Level [edit interfaces dln unit logical-unit-number dialer-options incoming-map],
[edit logical-systems logical-system-name interfaces dln unit logical-unit-number
Statement introduced in JUNOS Release 7.5.
Release Information
On J Series Services Routers with interfaces configured for ISDN, specify the dialer
Description
to accept a specified caller number or accept all incoming calls.
caller-id
Options
If the incoming caller ID has fewer digits than the number configured, it is not a valid
Only one B-channel can map to one dialer. If one dialer is already mapped, any other
accept-all
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
dialer-options incoming-map]
—Incoming caller number. You can configure multiple caller IDs on a dialer.
The caller ID of the incoming call is matched against all caller IDs configured on
all dialers. The dialer matching the caller ID is looked at for further processing.
Only a precise match is a valid match, For example, the configured caller ID
1-222-333-4444 or 222-333-4444 will match the incoming caller ID
1-222-333-4444.
match. Duplicate caller IDs are not allowed on different dialers; however, for
example, the numbers 1-408-532-1091, 408-532-1091, and 532-1091 can still
be configured on different dialers.
call mapping to the same dialer is rejected (except in the case of a multilink
dialer). If no dialer caller is configured on a dialer, that dialer will not accept any
calls.
—Any incoming call in an associated interface is accepted.
ISDN Interfaces Overview on page 871
JUNOS Software Interfaces and Routing Configuration Guide
Chapter 62: Summary of Interface Configuration Statements
1015
caller