Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 1255

interface (IEEE 802.1x)
Syntax interface interface-id {
}
[edit protocols dot1x authenticator]
Hierarchy Level
Statement introduced in JUNOS Release 9.3.
Release Information
Use this statement to configure the 802.1x Port-Based Network Access Control
Description
protocol-specific Ethernet interface options.
The default values are provided for the options below on the respective statement
Default
pages.
Options maximum-requests
quiet-period
reauthentication
retries
server-timeout
supplicant (single)
supplicant-timeout
maximum-requests integer;
quiet-period seconds;
reauthentication (disable | interval seconds);
retries integer;
server-timeout seconds;
supplicant (single);
supplicant-timeout seconds;
transmit-period seconds;
—Specify the maximum number of retransmission times for an
EAPOL Request packet to the client before it times out the authentication session.
—Specify the number of seconds the port remains in the wait state
following a failed authentication exchange with the client, before reattempting
the authentication.
—Includes two options:
—Periodic reauthentication of the client is disabled.
disable
—Specify the periodic reauthentication time interval.
interval
—Specify the number of tries after which the port remains in the wait state
for quiet-period seconds before reattempting the authentication.
—Specify the number of seconds the port waits for a reply when relaying
a response from the client to the authentication server before timing out and
invoking the server-fail action.
—Specify supplicant single mode. See the usage guidelines to
configure other modes.
—Specify the number of seconds the port waits for a response
when relaying a request from the authentication server to the client before
resending the request.
Chapter 62: Summary of Interface Configuration Statements
interface (IEEE 802.1x)
1185