Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 903

Configuring the PPPoE Underlying Interface
To configure the underlying Fast Ethernet, Gigabit Ethernet, 10-Gigabit Ethernet, or
ATM interface, include the
underlying-interface interface-name;
You can include this statement at the following hierarchy levels:
[edit interfaces pp0 unit logical-unit-number pppoe-options]
[edit logical-systems logical-system-name interfaces pp0 unit logical-unit-number
pppoe-options]
Specify the logical Ethernet, Fast Ethernet, Gigabit Ethernet, 10-Gigabit Ethernet, or
ATM interface as the underlying interface—for example,
fe-1/0/1.0 (Fast Ethernet interface), or
Identifying the Access Concentrator
When configuring a PPPoE client, identify the access concentrator by a unique name
by including the access-concentrator
access-concentrator name;
You can include this statement at the following hierarchy levels:
[edit interfaces pp0 unit logical-unit-number pppoe-options]
[edit logical-systems logical-system-name interfaces pp0 unit logical-unit-number
pppoe-options]
Configuring the PPPoE Automatic Reconnect Wait Timer
By default, after a PPPoE session is terminated, the session attempts to reconnect
immediately. When configuring a PPPoE client, you can specify how many seconds
to wait before attempting to reconnect, by including the
auto-reconnect seconds;
You can include this statement at the following hierarchy levels:
[edit interfaces pp0 unit logical-unit-number pppoe-options]
[edit logical-systems logical-system-name interfaces pp0 unit logical-unit-number
pppoe-options]
You can configure the reconnection attempt to occur in 0 through 4,294,967,295
seconds after the session terminates.
Chapter 57: Configuring Point-to-Point Protocol over Ethernet
statement:
underlying-interface
ge-2/0/0 (Gigabit Ethernet interface).
statement:
(ATM VC),
at-0/0/1.0
auto-reconnect statement:
833
Configuring PPPoE