Table of Contents
Advertisement
JUNOS 10.1 Network Interfaces Configuration Guide
Configuring Two EPD Thresholds per Queue
For ATM2 IQ interfaces configured to use Layer 2 circuit trunk mode, you can set
two EPD thresholds that depend on the PLPs of the packets. When you set a threshold
with the
you set a threshold with the
1. If you include the
epd-threshold
To configure two EPD thresholds, include the
You can include these statements at the following hierarchy levels:
The value you set with the
greater than the value you set with the
by interface type. See Table 29 on page 335.
For general information about EPD thresholds, see "Configuring the ATM2 IQ EPD
Threshold" on page 334.
Configuring the ATM2 IQ Transmission Weight
For ATM2 IQ interfaces configured with VPI shaping, you can control the number of
cells a VCI can send each time the VCI has a turn to transmit by including the
transmit-weight
You can include this statement at the following hierarchy levels:
VPI traffic shaping is not supported on point-to-multipoint interfaces.
336
Configuring Two EPD Thresholds per Queue
...
}
}
epd-threshold
statement, it applies to packets that have a PLP of 0. When
plp1
statement in the configuration, you must also include the
statement.
epd-threshold cells plp1 cells;
[edit interfaces interface-name atm-options scheduler-maps map-name
forwarding-class class-name]
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
epd-threshold
statement:
transmit-weight cells;
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
statement, it applies to packets that have a PLP of
plp1
epd-threshold
statement (for PLP0) should be equal to or
plp1
statement. EPD threshold ranges vary
and
statements:
plp1
Advertisement
Table of Contents
