Example: Configuring Nxds0 Interfaces; Configuring Channelized Oc12/Stm4 Iq Pics For Sdh Mode; Configuring An Unpartitioned Sdh (Vc-4-4C) Interface On A Channelized; Oc12/Stm4 Iq Pic - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
The time-slot range is from 1 through 32. You can designate any combination of
time slots. To configure ranges, use hyphens. To configure discontinuous time slots,
use commas. You can use a combination of ranges and discontinuous time slots, for
example:

Example: Configuring NxDS0 Interfaces

Configure channelized NxDS0 interfaces, using partition 4 and time slots 1 through
10:
This configuration creates interface
Configuring Channelized OC12/STM4 IQ Interfaces (SDH Mode)
The Channelized OC12 IQ PIC configured for SDH mode creates a single channelized
STM4 interface. You can configure this interface as unpartitioned using the
statement at the
SDH VC-4-4C interface, or you can partition it into the following OC slices:
This section describes how to configure the following channelized OC12 IQ interfaces
on a Channelized OC12 IQ PIC configured in SDH mode:
448
Configuring Channelized OC12/STM4 IQ Interfaces (SDH Mode)
1,9-18,21
[edit interfaces]
ce1-0/2/0:1:2:3 {
partition 4 interface-type ds0 timeslots 1-10;
}
[edit interfaces cstm4-fpc/pic/port]
SDH virtual concatenation 4 (VC-4) and channelized AU-4 interfaces (4 interfaces,
any combination)
Channelized T3 or T3 interfaces from a channelized AU-4 interface (3 interfaces,
any combination)
Channelized T1 or T1 interfaces from a channelized T3 interface (28 interfaces,
any combination)
NxDS0 interfaces from a channelized T1 interface
Configuring Channelized OC12/STM4 IQ PICs for SDH Mode on page 449

Configuring an Unpartitioned SDH (VC-4-4C) Interface on a Channelized

OC12/STM4 IQ PIC on page 449
Configuring SDH (VC-4) Interfaces on Channelized OC12/STM4 IQ PICs on page 449
Configuring Channelized AU-4 Interfaces on page 450
Configuring T3 or Channelized T3 Interfaces Under Channelized AU-4
Interfaces on page 451
Configuring T1 or Channelized T1 Interfaces Under Channelized AU-4
Interfaces on page 452
ds-0/2/0:1:2:4 .
hierarchy level to create a single
no-partition