Bandwidth - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide

bandwidth

bandwidth rate;
Syntax
Hierarchy Level [edit interfaces interface-name unit logical-unit-number],
[edit logical-systems logical-system-name interfaces interface-name unit logical-unit-number]
Statement introduced before JUNOS Release 7.4.
Release Information
Configure an informational-only bandwidth value for an interface. This statement is
Description
valid for all logical interface types, except multilink and aggregated interfaces.
Options rate
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
994
bandwidth
—Peak rate, in bits per second (bps) or cells per second (cps). You can specify a
value in bits per second either as a complete decimal number or as a decimal
number followed by the abbreviation
(1,000,000,000). You can also specify a value in cells per second by entering
g
a decimal number followed by the abbreviation
second are converted to bits per second by means of the formula
1 cps = 384 bps.
Range: Not limited.
Configuring the Interface Bandwidth on page 170
k (1000), m (1,000,000), or
c ; values expressed in cells per