Feac-Loop-Respond - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide

feac-loop-respond

(feac-loop-respond | no-feac-loop-respond);
Syntax
[edit interfaces interface-name t3-options]
Hierarchy Level
Statement introduced before JUNOS Release 7.4.
Release Information
For T3 interfaces only, configure the router so a remote CSU can place the local router
Description
into loopback.
If you configure remote or local loopback with the T3
does not respond to FEAC requests from the CSU even if you include the
feac-loop-respond
delete the
The router does not respond to FEAC requests.
Default
interface—To view this statement in the configuration.
Required Privilege Level
interface-control—To add this statement to the configuration.
Related Topics
1128
feac-loop-respond
statement in the configuration. For the router to respond, you must
statement from the configuration.
loopback
Configuring the T3 FEAC Response on page 593
loopback (ADSL, DS0, E1/E3, SONET/SDH, SHDSL, and T1/T3) on page 1246
remote-loopback-respond on page 1390
statement, the router
loopback