Example: Configuring Channelized Stm1 Interfaces - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

no-termination-request
hierarchy level:
The
configurations and works with PPP, PPP over Frame Relay, and MLPPP interfaces
only.
For information about interchassis and intrachassis LSQ failover, see the JUNOS
Services Interfaces Configuration Guide.

Example: Configuring Channelized STM1 Interfaces

The following configuration is sufficient to get the Channelized STM1-to-E1 PIC
interface up and running. The channelized STM1-to-E1 interface is an STM1 that is
divided into 63 E1 interfaces. E1 interfaces can use the following encapsulation types:
The channels can also have logical interfaces. For information about Frame Relay
DLCI limitations for channelized interfaces, see "Data-Link Connection Identifiers on
Channelized Interfaces" on page 396. For more information about Frame Relay DLCIs,
see "Configuring a Point-to-Point Frame Relay Connection" on page 388. For more
information about DLCI sparse mode, see the JUNOS System Basics Configuration
Guide.
You apply all STM1 interface SONET/SDH options to the first E1 interface in the
configuration by including the
e1-fpc/pic/port:channel]
statement at the
no-termination-request;
no-termination-request statement is supported only with MLPPP and SONET APS
PPP, PPP CCC, and PPP TCC
Frame Relay, Frame Relay CCC, and Frame Relay TCC
Cisco HDLC, Cisco HDLC CCC, and Cisco HDLC TCC
hierarchy level:
[edit]
interfaces {
e1-fpc/pic/port:0 {
encapsulation cisco-hdlc;
sonet-options {
no-z0-increment;
}
e1-options {
framing g704;
}
unit 0 {
family inet {
address 10.11.30.1/30;
}
}
}
e1-fpc/pic/port:1 {
encapsulation frame-relay;
e1-options {
framing g704;
Chapter 21: Configuring Channelized STM1 Interfaces
[edit interfaces interface-name ppp-options]
sonet-options statement at the
Example: Configuring Channelized STM1 Interfaces
[edit interfaces
487