Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 564

JUNOS 10.1 Network Interfaces Configuration Guide
are valid for this configuration, and the
statements at the
Likewise, only a subset of the DS0 options are valid for this configuration, and the
bert-algorithm
[edit interfaces interface-name ds0-options]
configurations list all the valid parameters.
NOTE: The set of options the JUNOS Software applies to the interface depends on
how you specify the interface name. For more information, see "Examples:
Configuring Channelized DS3-to-DS0 Interfaces" on page 497.
To specify options for the T3 side of the connection, include the
at the
The statements at the
are ignored if configured on other channels. To specify options for each of the T1
channels, include the
hierarchy level:
To specify options for each of the DS0 channels, include the
at the
494
Configuring Channelized DS3-to-DS0 Interfaces
[edit interfaces interface-name t1-options]
,
bert-error-rate
[edit interfaces interface-name]
[edit interfaces interface-name]
t3-options {
bert-algorithm algorithm;
bert-error-rate rate;
bert-period seconds;
(cbit-parity | no-cbit-parity);
(long-buildout | no-long-buildout);
loopback (local | payload | remote);
}
t3-options
t1-options
[edit interfaces interface-name]
t1-options {
byte-encoding (nx56 | nx64);
fcs (16 | 32);
framing (esf | lf);
idle-cycle-flag (flags | ones);
invert-data;
loopback (local | payload | remote);
start-end-flag (filler | shared);
timeslots time-slot-number;
}
[edit interfaces interface-name]
[edit interfaces interface-name]
ds0-options {
bert-algorithm algorithm;
bert-error-rate rate;
bert-period seconds;
byte-encoding (nx56 | nx64);
fcs (16 | 32);
idle-cycle-flag (flags | ones);
invert-data;
,
buildout invert-data
, , and
bert-period loopback payload
hierarchy level are ignored. The following
hierarchy level:
hierarchy are supported only for channel 0; they
statement at the [edit interfaces interface-name]
hierarchy level:
, and
line-encoding
hierarchy level are ignored.
statements at the
statement
t3-options
ds0-options statement