Toyota Tundra 2005 Service - Repair - Maintenance page 3589

BP-16
INSTALLATION
_ Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension
diagram. (See the body dimension diagram)
_ Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the
finish.
_ After welding, apply the polyurethane foam to the corresponding parts.
_ After welding, apply body sealer and under-coating to the corresponding parts.
_ After applying the top coat layer, apply anti-rust agent to the inside of the necked section structural weld spots.
POINT
1 Before temporarily installing the new parts, weld the [A], [B], [C], [D], [E], [F], [G], [H] and [I] with standard
points.
PART NAME
[A] Side Panel No.1 Retainer
[D] Front Body Upper Inner Pillar
[F] Front Pillar To Cowl Side Panel No.1 Bracket
[H] Fuse Box Mounting No.2 Bracket
120 mm (4.72 in.)
BODY PANEL REPLACEMENT
[B] Front Body Pillar Lower Reinforce
[E] Cowl Side Inner Panel
[I] Front Pillar To Cowl Side Panel No.2 Bracket
200 mm (7.87 in.)
[C]
[G] Computer To Cowl Side No.5 Bracket
F16934
Outer Panel