Toyota Tundra 2005 Service - Repair - Maintenance page 3593

Hide thumbs Also See for Tundra 2005:

Table of Contents

INSTALLATION

_ Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension

diagram. (See the body dimension diagram)

_ Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the

_ After welding, apply the polyurethane foam to the corresponding parts.

_ After welding, apply body sealer and under-coating to the corresponding parts.

_ After applying the top coat layer, apply anti-rust agent to the inside of the necked section structural weld spots.

Before temporarily installing the new parts, weld the [A], [B] and [C] with standard points.

Rocker Panel Reinforcement

Center Body Pillar Lower Reinforce

300 mm (11.81 in.)

BODY PANEL REPLACEMENT

Center Body Pillar Upper Reinforce

370 mm (14.57 in.)