Dell C9000 Series Reference Manual page 337

Parameters
mac-list-name
Defaults Not configured.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage Information The system supports one ingress and one egress MAC ACL per interface.
The number of entries allowed per ACL is hardware-dependent. For detailed
information on the number entries allowed per ACL on the C9000, refer to the Content
Addressable Memory (CAM) chapter in the C9000 Configuration Guide.
Use this command in Configuration Terminal Batch mode to configure a standard MAC
ACL, name in a dual-homing setup.
Example
Dell(conf)#mac-access-list access-list standard TestMAC
Dell(config-std-macl)#?
deny
description
exit
no
permit
remark
Enter a text string as the name of the standard MAC access list
(140 character maximum).
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters. Prior
to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Specify packets to reject
List description
Exit from access-list configuration mode
Negate a command or set its defaults
Specify packets to forward
Specify access-list entry remark
Access Control Lists (ACL) 337