The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
8.4.1.0
Usage Information If the host responds to 802.1X with an incorrect login/password, the login fails. The
switch attempts to authenticate again until the maximum attempts configured is
reached. If the authentication fails after all allowed attempts, the interface moves to the
authentication failed VLAN.
After the authentication VLAN is assigned, the port-state must be toggled to restart
authentication. Authentication occurs at the next reauthentication interval (dot1x
reauthentication).
Use this command in Configuration Terminal Batch mode to configure the
authentication failure in a dual-homing setup.
Related
Commands
dot1x auth-server
Configure the authentication server to RADIUS.
C9000 Series
Syntax
dot1x auth-server radius
Defaults
none
Command Modes
CONFIGURATION
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
•
dot1x port-control
•
dot1x guest-vlan
•
show dot1x interface
802.1X
241