Ip Access-Group - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.2.1.1

ip access-group

Assign an IP access list (IP ACL) to an interface.
C9000 Series
Syntax
ip access-group access-list-name {in | out} [implicit-permit]
[vlan vlan-id]
To delete an IP access-group configuration, use the no ip access-group access-
list-name {in | out} [implicit-permit] [vlan vlan-id] command.
Parameters
access-list-name
in
out
implicit-permit
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increase the name string to accept up to 140 characters. Prior to
7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the name of a configured access list, up to 140 characters.
Enter the keyword in to apply the ACL to incoming traffic.
Enter the keyword out to apply the ACL to outgoing traffic.
(OPTIONAL) Enter the keyword implicit-permit to change
the default action of the ACL from implicit-deny to implicit-
permit (that is, if the traffic does not match the filters in the ACL,
the traffic is permitted instead of dropped).
Access Control Lists (ACL) 272