Dell C9000 Series Reference Manual page 313

Networking command-line reference guide
Hide thumbs Also See for C9000 Series:
Table of Contents

Advertisement

dscp
Enter the keyword dscp to deny a packet based on the DSCP
value. The range is from 0 to 63.
operator
(OPTIONAL) Enter one of the following logical operand:
port port
Enter the application layer port number. Enter two port numbers
if you are using the range logical operand. The range is 0 to
65535.
destination
Enter the IP address of the network or host to which the packets
are sent.
count
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
bytes
(OPTIONAL) Enter the keyword bytes to count bytes processed
by the filter.
order
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order numbers
have a higher priority). If you do not use the keyword order, the
ACLs have the lowest order by default (255).
fragments
Enter the keyword fragments to use ACLs to control packet
fragments.
log
(OPTIONAL) Enter the keyword log to include ACL matches in
the log.
threshold-in msgs
(OPTIONAL) Enter the threshold-in-msgs keyword followed
count
by a value to indicate the maximum number of ACL logs that
can be generated, exceeding which the generation of ACL logs
is terminated with the seq, permit, or deny commands. The
threshold range is from 1 to 100.
interval minutes
(OPTIONAL) Enter the keyword interval followed by the time
period in minutes at which ACL logs must be generated. The
threshold range is from 1 to 10 minutes.
monitor
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL in
which you are creating the rule is applied to the monitored
interface. For more information, refer to the "Flow-based
Monitoring" section in the Port Monitoring chapter of the Dell
Networking OS Configuration Guide.
eq = equal to
neq = not equal to
gt = greater than
lt = less than
range = inclusive range of ports (you must specify two
ports for the port parameter)
Access Control Lists (ACL)
313

Advertisement

Table of Contents
loading

Table of Contents