Mac Access-Group - Dell C9000 Series Reference Manual

Usage Information Use this command in Configuration Terminal Batch mode to enable user egress ACL
for L2 control traffic in a dual-homing setup.

mac access-group

Apply a MAC ACL to traffic entering or exiting an interface. You can apply a MAC ACL on a physical, port-
channel, or VLAN interface.
C9000 Series
Syntax
mac access-group access-list-name {in [vlan vlan-range] | out}
To delete a MAC access-group, use the no mac access-group mac-list-name
command.
Parameters
access-list-name
vlan vlan-range
in
out
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Enter the name of a configured MAC access list, up to 140
characters.
(OPTIONAL) Enter the keyword vlan and then enter a range of
VLANs. The range is from 1 to 4094 (you can use IDs 1 to 4094).
NOTE: This option is available only with the keywordin
option.
Enter the keyword in to configure the ACL to filter incoming
traffic.
Enter the keyword out to configure the ACL to filter outgoing
traffic.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Access Control Lists (ACL) 330