Dot1X Static-Mab - Dell C9000 Series Reference Manual

calculated according to the following formula: dot1x server-timeout seconds >
(radius-server retransmit seconds + 1) * radius-server timeout seconds.
Where the default values are as follows: dot1x server-timeout (30 seconds),
radius-server retransmit (3 seconds), and radius-server timeout (5 seconds).
For example:
Dell(conf)#radius-server host 10.11.197.105 timeout 6
Dell(conf)#radius-server host 10.11.197.105 retransmit 4
Dell(conf)#interface tengigabitethernet 2/23
Dell(conf-if-te-2/23)#dot1x server-timeout 40
Use this command in Interface Batch Mode to configure the server time-out in a dual-
homing setup.

dot1x static-mab

Enable static MAC authorization bypass (MAB) and configure static MAB profile to an interface.
Syntax
[no] dot1x static-mab profile profile-name
Parameters
profile profile-
name
Defaults Disabled.
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
Usage Information The dot1x static-mab command enables static MAB (mac auth bypass) and
configures the associated profile on a dot1x interface. Static MAB bypasses the
Enter the keyword profile and the profile-name to configure
the static MAB profile name. The profile name length is limited
to 32 characters.
Description
Introduced on the S3100 series, S4048–ON, S4048–ON, S4810,
S4820T, S5000, S6000, S6000–ON, the Configuration Terminal
Batch mode on C9010, Z9100–ON, and Z9500.
Introduced on the C9010.
802.1X 258