Ip Access-List Standard - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Usage Information Use the order option only when you use policy-based QoS on the switch. For more

information, refer to the Quality of Service chapter of the C9000 Series Configuration

When you use the log option, the CP processor logs detail the packets that match.

Depending on how many packets match the log entry and at what rate, the CP may

become busy as it has to log these packets' details.

By default, 10 ACL logs are generated if you do not specify the threshold explicitly. The

default frequency at which ACL logs are generated is five minutes. By default, flow-

based monitoring is not enabled.

Use the monitor option only when you are using flow-based monitoring. For more

information, refer to the Port Monitoring chapter of the C9000 Series Configuration

The software cannot count both packets and bytes, so when you enter the count byte

options, only bytes are incremented.

ip access-list standard

ip access-list standard

Create a standard IP access list (IP ACL) to filter based on IP address.

C9000 Series

ip access-list standard access-list-name

To delete an access list, use the no ip access-list standard access-list-

name command.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.

Added support for the non-contiguous mask and added the

monitor option.

Expanded to include the optional QoS order priority for the

— configures a standard ACL.

— configures a permit filter.

Access Control Lists (ACL)

Table of Contents