Dot1X Server-Timeout - Dell C9000 Series Reference Manual

dot1x server-timeout

Configure the amount of time after which exchanges with the server time-out.
C9000 Series
Syntax
dot1x server-timeout seconds
To return to the default, use the no dot1x server-timeout command.
Parameters
seconds
Defaults 30 seconds
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
7.6.1.0
7.4.1.0
Usage Information When you configure the dot1x server-timeout value, take into account the
communication medium used to communicate with an authentication server and the
number of RADIUS servers configured. Ideally, the dot1x server-timeout value (in
seconds) is based on the configured RADIUS-server timeout and retransmit values and
Enter a time-out value in seconds. The range is from 1 to 300,
where 300 is implementation dependant. The default is 30.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
802.1X 257