Dot1X Critical-Vlan - Dell C9000 Series Reference Manual

Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.12.0
8.3.11.1
7.6.1.0
7.4.1.0
Usage Information Use this command to enable dot1x on an interface. Use in the Interface Batch Mode to
enable dot1x on an interface in a dual-homing setup.
Related dot1x authentication (Configuration)
Commands

dot1x critical-vlan

Configure critical-VLAN for users or devices when authentication server is not reachable.
Syntax
[no] dot1x critical-vlan vlan-id
Parameters
vlan-id
Defaults Not Configured.
Command Modes
INTERFACE
INTERFACE (BATCH MODE)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
Enter the VLAN identifier. The VLAN-ID range is from 1 to 4094.
Description
Introduced on the S3100 series, S4048–ON, S4048–ON, S4810,
S4820T, S5000, S6000, S6000–ON, the Configuration Terminal
Batch mode on C9010, Z9100–ON, and Z9500.
Introduced on the C9000 Series.
802.1X 245