Show Dot1X Cos-Mapping Interface - Dell C9000 Series Reference Manual

Version
9.10(0.0)
9.9(0.0)
Usage Information The mac command configures a list of supplicant MAC addresses for a dot1x profile
represented with a profile-name. You can configure up to 6 MAC addresses in a single
mac command. The maximum number of MAC addresses that you can configure in a
single profile is limited to 100.
Use this command in Configuration Terminal Batch mode to configure a list of
supplicant MAC addresses for dot1x profile in a dual-homing setup.
Example
Dell(conf)#dot1x profile mySupplicants
Dell(conf-dot1x-profile)#mac 00:50:56:AA:01:10 00:50:56:AA:01:11
Dell(conf-dot1x-profile)#show config
dot1x profile mySupplicants
mac 00:50:56:aa:01:10
mac 00:50:56:aa:01:11
Dell(conf-dot1x-profile)#
Dell(conf-dot1x-profile)#exit

show dot1x cos-mapping interface

Display the CoS priority-mapping table the RADIUS server provides and applies to authenticated supplicants
on an 802.1X-enabled system.
C9000 Series
Syntax
show dot1x cos-mapping interface interface [mac-address mac-
address]
Parameters
interface
mac-address
Description
Introduced on the S3100 series, S4048–ON, S4048–ON, S4810,
S4820T, S5000, S6000, S6000–ON, the Configuration Terminal
Batch mode on C9010, Z9100–ON, and Z9500.
Introduced on the C9010.
Enter one of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
(Optional) MAC address of an 802.1X-authenticated supplicant.
802.1X 262