Permit - Dell C9000 Series Reference Manual

permit

To pass IP packets meeting the filter criteria, configure a filter.
C9000 Series
Syntax
permit {source mask | any | host ip-address} {destination mask |
any | host ip-address} [count [bytes]] [dscp value] [order]
[fragments] [log [interval minutes] [threshold-in-msgs [count]]
[monitor]
To remove this filter, you have two choices:
Parameters
source
mask
any
host ip-address
destination
count
bytes
dscp
order
fragments
• Use the no seq sequence-number command if you know the filter's sequence
number.
• Use the no deny {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Enter the IP address in dotted decimal format of the network
from which the packet was sent.
(OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject to
the filter.
Enter the keyword host then the IP address to specify a host IP
address or hostname.
Enter the IP address of the network or host to which the packets
are sent.
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
(OPTIONAL) Enter the keyword bytes to count bytes processed
by the filter.
(OPTIONAL) Enter the keyword dcsp to match to the IP DSCP
values. The range is from 0 to 63.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order numbers
have a higher priority). If you do not use the keyword order, the
ACLs have the lowest order by default (255).
Enter the keyword fragments to use ACLs to control packet
fragments.
Access Control Lists (ACL) 304