Commands Common To All Acl Types; Remark - Dell C9000 Series Reference Manual

Commands Common to all ACL Types

The following commands are available within each ACL mode and do not have mode-specific options. Some
commands in this chapter may use similar names, but require different options to support the different ACL
types (for example, the deny and permit commands).

remark

Enter a description for an ACL entry.
C9000 Series
Syntax
remark [remark-number] [description]
Parameters
remark-number
description
Defaults Not configured.
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
Enter the remark number. The range is from 0 to 65535.
Enter a description of up to 80 characters.
• CONFIGURATION-IP ACCESS LIST-STANDARD
• CONFIGURATION-IP ACCESS LIST-EXTENDED
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
NOTE: You can use the same sequence number for the
remark and an ACL rule.
Access Control Lists (ACL) 269