Dell C9000 Series Reference Manual page 303

Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.10.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed
information on the number entries allowed per ACL on the switch, refer to the Content
Addressable Memory (CAM) chapter in the C9000 Series Configuration Guide.
If you configure an extended IP ACL to be used only to filter protocol traffic for CoPP,
you must enter the keyword cpu-qos.
Use this command in Configuration Terminal Batch mode to configure the extended IP
access list (IP ACL) in a dual-homing setup.
Example
Dell(conf)#ip access-list extended TESTListEXTEND
Dell(config-ext-nacl)#
Related
ip access-list standard
Commands
show config
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters. Prior
to 7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures a standard IP access list.
— displays the current configuration.
Access Control Lists (ACL) 303