08-108 Tray 3 or Tray 4 Paper Feed Jam RAP
08-108 The lead edge of the paper was late to tray 2 feed sensor when feeding from tray 3 or
tray 4.
Initial Actions
•
Check the condition of the paper in tray 3 and tray 4. Refer to IQ1 and GP 20.
•
Check for obstructions in the paper path.
•
Check that the left hand door is latched correctly.
•
Check that the interlock cover has not come loose, PL 7.30 Item 23. Bias the cover to the
right and tighten the two screws
•
Ensure that the tray is pushed fully home.
Procedure
NOTE: The front door interlock must be cheated when checking +24V components.
Enter dC330 code 08-102 tray 2 feed sensor, Q08-102. Press Start. Manually actuate the sen-
sor. The display changes.
Y
N
Go to Flag 1. Check Q08-102. Refer to:
•
GP 11 How to Check a Sensor.
•
P/J276, Tray 1 and 2 control PWB.
•
01E +5V Distribution RAP.
•
01B 0V Distribution RAP.
Install new components as necessary:
•
Tray 2 feed sensor, PL 7.30 Item 24.
•
Tray 1 and 2 control PWB, PL 7.10 Item 2.
Enter dC330 code 08-045 tray 3 and 4 transport motor, MOT08-045. Press Start. The
runs.
Y
N
Go to Flag 2. Check MOT08-045. Refer to:
•
GP 10 How to Check a Motor.
•
P/J398, HCF control PWB.
•
01G +24V Distribution RAP.
•
01B 0V Distribution RAP.
Install new components as necessary:
•
Tray 3 and 4 transport motor, PL 8.30 Item 7.
•
HCF control PWB, PL 7.20 Item 2.
A
Status Indicator RAPs
08-108
A
The transport rolls rotate.
Y
N
Check the gears and drive belt, PL 8.30 Item 8, PL 8.30 Item 9, GP 7.
Perform the following:
•
Check the tray 3 and tray 4 transport rolls, PL 8.30 Item 18, GP 7.
•
If the fault occurs when feeding from tray 4. Go to RAP 08-104, 08-114 Tray 4 Misfeed
RAP.
•
If the fault occurs when feeding from tray 3. Check the following, GP 7:
–
The takeaway roll assembly, PL 8.35 Item 2.
–
The transport roll assembly, PL 8.35 Item 11.
–
The transport roll bearing, PL 8.35 Item 3.
–
Go to RAP 08-103, 08-113 Tray 3 Misfeed RAP
motor
August 2007
2-202
WorkCentre 5687 Family