Die Set Configuration; Pin Numbering; Pin Removal Table For Us Paper Sizes - Xerox Versant 80 Press User Manual

Firmware
This displays the current level of firmware on the AdvancedPunch Pro.
Die Sets

Die Set Configuration

The die sets for the AdvancedPunch Pro are intended to work with multiple paper sizes
and feed directions. In order to accommodate different sheet sizes the die set must be
configured to the correct number of punching pins, and the die stop must be set to the
proper position. The die label contains information on the common paper punching
sizes. For the uncommon sizes, refer to these two tables:
Sizes and Pin Removal Table for ISO Paper

Pin Numbering

Die punching pins are numbered sequentially starting from the handle end. The following
illustration shows a 47-hole coil die set as an example; the Pin Number 1 and Pin Number
47 (last pin) locations are indicated in the illustration.
Note
All square and round hole die sets follow the same pin numbering format.
Tables

Pin Removal Table for US Paper Sizes

show the information on which pins need to be removed to correctly punch each sheet
size and configuration that the AdvancedPunch Pro can accept. For standard-offering
dies that are not found in the chart no pin adjustment is necessary.
Pin Removal Table for US Paper Sizes
US Paper Coil Wire 2:1
Size Round Round
Pin Numbers to Remove Based On Paper Size or Orientation
LTR LEF 2, 47 1, 23
LTR SEF 7, 42 None
Statement 7, 42 None
LEF
® ®
Xerox Versant 80 Press
User Guide
Pin Removal Table for US Paper
Sizes.
and Pin Removal Table for ISO Paper Sizes
Wire 3:1 3, 5, or 7 Comb-
Round Hole (8 Bind
mm)
1, 34 3H, 5H, 7H 1, 21
5, 31 N/A None
5, 31 N/A None
GBC AdvancedPunch Pro
Wire 2:1 Wire 3:1
Square Square
1, 23 2, 47
None 7, 42
None 7, 42
22-7