Setting Stimulus Conditions; Setting The Sweep Type; Setting The Sweep Range - Agilent Technologies E5071C Manual

Setting Stimulus Conditions

You can set the stimulus condition for each channel independently.

Setting the Sweep Type

•

Setting the Sweep Range

•
Enable Stimulus Signal Output
•
Setting power level
•
Setting fixed frequency at power sweep
•
Setting CW Time Sweep
•
Setting Power Level with Auto Power Range
•
Setting the Number of Points
•
Setting the Sweep Time
•
Other topics about Setting Measurement Conditions
Setting the Sweep Type
You can select the sweep type from the following four types.
SoftKey Description
Sweeps frequencies in linear scale.
Linear
Freq
Sweeps frequencies in logarithmic scale.
Log Freq
Performs a sweep with linear sweep conditions (segments) combined.
Segment
For more information, refer to Performing a Segment-by-Segment
Sweep (segment sweep).
Sweeps power levels in linear scale.
Power
Sweep
The procedure for selecting the sweep type is as follows:
1. Press
Channel Next/Channel Prev
you want to set the sweep type.
2. Press
Sweep Setup
3. Press the desired softkey to select the sweep type.
4. To use the E5071C in CW Time sweep, refer to Setting CW Time
Sweep
Setting the Sweep Range
keys to select the channel for which
> Sweep Type.
Measurement
83