Recall Procedure - Agilent Technologies E5071C Manual

Hide thumbs Also See for E5071C:

Table of Contents

If D:\Autorec.sta is found on the system at startup, the E5071C

is automatically configured using the saved settings. When the

external floppy disk drive is connected as A: drive, then if

A:\Autorec.sta is found at startup, the E5071C is also

automatically configured using the saved settings. If both files

are found, A:\Autorec.sta is recalled. To disable the auto recall

function, delete the Autorec.sta files.

An asterisk (*) in the upper right of the softkey indicates that

the corresponding file of the softkey already exists. If you save

into the existing file, the existing file is copied as backup.sta and

then overwritten.

Recall Procedure

Follow the procedure below to recall internal data from the E5071C.

1. If you recall a file that includes traces (its content was set to

State &Trace or All when it was saved), the trigger source is

automatically set to Manual.

2. Click Recall State.

When you want to recall State01.sta - State08.sta, Autorec.sta

1. Press State01 - State08 or Autorec.

When you want to recall other files

1. Press File Dialog... to open the Open dialog box.

2. Select the folder and the file using the external keyboard and mouse.

3. Click Open.

The following warning messages may appear when recall fails:

Model Mismatch

Autorec.sta files.

Save the instrument state as user preset. The user can

preset the analyzer at user saved status.

Save the instrument state as your desired file name. You

can enter a file name using the Input from the front panel

buttons on the dialog box when storing a file.

This message is displayed when the state file of

E5070B/E5071B is recalled by E5071C options 2D5, 4D5,

2K5 and 4K5 .

Show Quick Links

Table of Contents