Troubleshooting; Troubleshooting During Startup - Agilent Technologies E5071C Manual

E5071C

Troubleshooting

Troubleshooting
This section describes the steps you should take when you believe the
Agilent E5071C is operating improperly. The results of these simple
investigative procedures may help you avoid the down-time and
inconvenience of repair service. The troubleshooting instructions are
divided into three categories.
When taking all solution but it does not work. Contact Agilent Technology's
Customer Contact.

Troubleshooting during Startup

•
Troubleshooting during Operation
•
Troubleshooting for External Devices
•
Troubleshooting during Startup
Symptom
Turning on (|) the standby switch does
not start up the system.
The system starts up, but it automatically
shuts down immediately.
The system starts up, but it enters the
service mode (The instrument status bar
in the lower right part of the screen
displays SVC in red).
The measurement screen appears after
startup, but the date and time displayed
on the instrument status bar in the lower
right part of the screen differ greatly from
the previous settings.
The measurement screen appears after
startup, but the power-on test is failed,
with Error Message 241 appearing against
a red background in the instrument
828
Solution
Confirm that the
•
power cable is
properly plugged in.
Confirm that the line
•
switch on the rear
panel is turned on.
Execute the system
recovery.
Execute the system
recovery.
Execute the system
recovery.
Execute the system
recovery.