Agilent Technologies E5071C Manual page 531

E5071C
No. Message
- Data out
222 of range
- Data type
104 error
63 Duplicate
trace
name
E
No. Message
32 ECal
module not
in
appropriate
RF path
502 Equation
run time
758
Description
A data element (not violating the standard)
outside the range defined by this instrument has
been received. This error occurs when an integer-
based command for which the parameter can be
rounded exceeds the range of -65536 to +65536
or when a real-number-based command for which
the parameter can be rounded exceeds the range
of -9.9e37 to +9.9e37, for example.
This error occurs also when a numeric value other
than a specified one is entered into a command in
which the "port number" and "CalKit number" are
specified as parameters and hence the parameters
are not rounded. Such commands are, for
example, CALC:FSIM:BAL:TOP:BBAL:PPOR,
SENS:CORR:COLL:ACQ:OPEN,
SENS:CORR:COLL:ECAL:SOLT3,
SENS:CORR:COLL:CKIT:ORD:LOAD, etc.
The parser has recognized a data element that
must not exist. Block data has been sent instead
of numeric value data or character string data that
had been expected, for example.
This error occurs when a trace name defined with
CALCulate[1-160]:PARameter[1-16]:TNAMe:DATA
command already exist.
Description
This error occurs when an ECal command,
SENS:CORR:COLL:ECAL:SOLTn or
SENS:CORR:OFFS:COLL:ECAL:xxxx, is executed
with the port on the ECal module not connected
correctly to the instrument. When the auto-
detect function is turned OFF, (SENS:CORR:COLL
:ECAL:ORI OFF), however, this error does not
occur even when the port on the ECal module is
not connected correctly to the instrument.
This error occurs under the following conditions: