Remote Control Using Http; Enabling Web Server; Network Configuration; Access From An External Pc - Agilent Technologies E5071C Manual

Remote Control Using HTTP

Enabling Web Server

•
Browser Web Control
•
Other topics about Setting Control Functions
You can access the web page installed in the E5071C by using the
hypertext transfer protocol (http) and the E5071C's IP address from the
external PC's web browser. This function is called an web-enabled
analyzer. Through the built-in web page, you can control the E5071C
remotely and display the measurement screen on external PCs.
The following browsers are recommended:
Internet Explorer 6.0 and later
•
Enabling Web Server

Network Configuration

To use web server, you have to configure the E5071C's network correctly.
For detailed information on configuration and notes, see Configuring the
Network.
Enabling Web Server
Enable the web server for the E5071C so that it may allow access from an
external PC. Follow these steps:
1. Press
System
2. Click Misc Setup > Network Setup.
3. Click Web Server to turn it ON.

Access from an external PC

1. Execute web browser on your PC.
2. Check IP address of the E5071C.
3. Enter IP address of the E5071C in the address bar and press Enter.
The following screen appears:
Key.
Setting Control Functions
725