Setting Up Beep; Setting Up Conditions To Make A Beep Sound; Making A Beep Sound - Agilent Technologies 4288A Programming Manual

Setting Up Beep

Setting up conditions to make a beep sound

To turn ON/OFF the beep sound, use one of the following commands. You can use either of
these two commands since both functions are identical.
• :CALC:COMP:BEEP on page 135
• :SYST:BEEP:STAT on page 191
To set the conditions to make a beep sound according to the comparator sorting result, use
the following command.
:CALC:COMP:BEEP:COND on page 136
•
The table below shows the relationship between the settings made by the above commands
and the condition to make a beep.
Setting of
:CALC:COMP:BEEP or :CALC:COMP:BEEP:
:SYST:BEEP:STAT
OFF
ON

Making a beep sound

To make a beep sound, use the following command:
:SYST:BEEP on page 191
•
Chapter 3
Setting Up Measurement Conditions and Display
Setting of
Condition to make a beep
COND
——— Never make a beep sound
•When wrong key
FAIL
operation is
performed.
•When an error,
alarm, or other
message is output.
PASS
Setting Up Beep
•When the sorting
judgment result of the
comparator is
OUT_OF_BIN or
AUX_BIN.
•When the sorting
judgment result of the
comparator is within
BIN1 to BIN9.
29