Agilent Technologies E5071C Manual page 802

•
:SENS{1-36}:CORR:OFFS:COLL:OPEN
•
:SENS{1-36}:CORR:OFFS:COLL:SHOR
•
:SENS{1-36}:CORR:OFFS:COLL:LOAD
•
:SENS{1-36}:CORR:OFFS:COLL:THRU
Measuring Power
You can use the following command to measure power.
:SENS{1-36}:CORR:OFFS:COLL:PMET
Power measurement is required for scalar-mixer calibration, but
•
it is not required for 1-port calibration. The setting for power
measurement is the same as for the normal power calibration.
For information on power calibration, refer to Power Calibration.
Calculation of scalar-mixer calibration coefficient
If the needed measurement is completed for the calibration port and type
you have selected, use the following command to start calculation of
calibration coefficients.
:SENS{1-36}:CORR:OFFS:COLL:SAVE
If the necessary measurement is not completed, an error will
•
occur. Once the calculation of calibration coefficients is
completed, the measurement values are cleared despite
whether they were used and error correction is turned on
automatically.
Turning ON/OFF scalar-mixer error correction
To turn on or off scalar-mixer error correction, use the following command.
This command is commonly used for the normal calibration; scalar-mixer
calibration data are enabled while the frequency offset is turned on, and
the normal calibration data are enabled while it is turned off.
:SENS{1-36}:CORR:STAT
Once the scalar-mixer calibration coefficient has been
•
calculated, scalar-mixer correction is automatically turned on.
Implementing scalar-mixer calibration with ECal
An ECal (Electronic Calibration) module allows you to perform scalar-mixer
calibration and 1-port calibration without needing to replace the standard
device.
To perform ECal, use one of the following commands:
Programming
1029