Items That Can Be Set For Each Segment; Sweep Delay/Sweep Time In Segment Sweep - Agilent Technologies E5071C Manual

The start frequency of segment 1 must be greater than lowest
•
frequency and the stop frequency of the last segment less than
highest frequency, as per the frequency range depending on the
option.
When the start frequency and stop frequency of a segment are not
•
the same, you can define from 2 to 1601 points in a segment.
When the start frequency and stop frequency of a segment are the
•
same, you can define from 1 to 1601 points in a segment.
You can set the total number of points in the segment table from 2
•
to 1601.
You can set the number of segments in the segment table to
•
between 1 and 201.
You can turn ON or OFF segments.
•

Items that can be set for Each Segment

For the segment sweep, you can set the sweep range, the number of
points, IF bandwidth, power level, sweep delay time, sweep mode, sweep
time and segment ON/OFF for each segment.
You can set the items in the following table to ON/OFF for each segment. If
you enable the segment-by-segment setting, you can make the setting for
each segment in the segment table; if you disable it, the setting in the
following table is used.
Item
IF bandwidth
Power level
Sweep delay
time
Sweep mode
Sweep time
Segment
ON/OFF

Sweep Delay/Sweep Time in Segment Sweep

When segment-by-segment setting is disabled
For all segments, the IF bandwidth for the linear/log
sweep (set with
Avg
For all segments, the power level for the linear/log
sweep (set with
Sweep Setup
For all segments, 0 is set.
For all segments, the sweep mode for the linear/log
sweep (set with
Sweep Setup
set.
For all segments, the auto sweep time mode is set.
For all segments, ON is set.
key > IF Bandwidt
key > Power) is set.
key > Sweep Mode) is
Measurement
) is set.
h
385