Acquisition Status Of Calibration Coefficient For Each Channel - Agilent Technologies E5071C Manual

Hide thumbs Also See for E5071C:

Table of Contents

You can check the status of the error correction actually executed for each

trace with the trace status area.

For a trace for which error correction is executed, the applied calibration

type is indicated in the trace status area by the symbols in the table below.

Calibration type

Open response calibration

Short response calibration

Thru response calibration

Enhanced response calibration

1-port calibration

Full 2-port calibration/2-port TRL calibration

Full 3-port calibration/3-port TRL calibration

Full 4-port calibration/4-port TRL calibration

If none of the symbols described above is displayed, error correction is not

executed for the trace.

Acquisition Status of Calibration Coefficient for Each Channel

You can check the acquisition status of the calibration coefficient for each

channel with the calibration property.

The calibration property displays the acquisition status of the calibration

coefficient between test ports for each channel in matrix format. The

following figure shows an example of when the calibration coefficients have

been acquired for the full 2-port calibration between test ports 1 and 2, the

response calibration for test port 3, and the response calibration (THRU)

between test ports 4 and 3.

Example of calibration property display

Show Quick Links

Table of Contents