Agilent Technologies E5071C Manual page 808

•
:ABOR
•
*RST
When the trigger system is in "Hold" state and one of the channels
switches to "Initiate" state (arrow "f" in the above figure), the trigger
system switches to "Waiting for Trigger" state (arrow "a" in the above
figure).
"Waiting for Trigger" State
When the trigger system is in "Waiting for Trigger" state and either the
instrument is triggered (i.e., a trigger is detected) or one of the following
commands is executed, the trigger system switches to "Measurement"
state (arrow "b" in the above figure)
•
:TRIG
•
:TRIG:SING
As shown in the table below, the instrument is triggered differently
depending on which trigger source is specified. To specify the trigger
source, use the :TRIG:SOUR command.
Trigger How instrument is
Source triggered
The instrument is
Internal
automatically triggered
trigger
within itself.
The instrument is
triggered when a
External trigger signal is input
trigger through the Ext Trig
terminal or the handler
interface
The instrument is
Bus triggered when the
trigger *TRG command is
issued.
The instrument is
Manual triggered when you
trigger press
on the front panel.
"Measurement" State
> Trigger
Trigger
Programming
1035