Agilent Technologies E5071C Manual page 442

Assign test port T1 to port 2.
Assign test port R1+ to port 3.
Assign test port R1- to port 4.
4. Assign test ports for channels 2, 3, and 4. Press the
to switch the active channel and then make the same setting of
channel 1.
5. Enable the control of the E5091A.
Setting Description
Enable the control of the
E5091A.
4. Setting Control Line
1. Set the bits of the control line for channel 1.
Setting Description
Set channel 1 to the active
channel.
Line 1: Low
Line 2: High
2. Set the control line for channels 2, 3, and 4 according to the same
procedure of channel 1.
5. Setting Sweep Conditions
1. Set the sweep conditions for channel 1.
Setting Description
Set channel 1 to the active
channel.
Start frequency: 400 MHz
Stop frequency: 1.4 GHz
Port2 > T1
Port3 > R1+
Port4 > R1-
Key Operation
Control (set it to ON)
Key Operation
Channel Next
Control Lines (check only)
Control Lines > Line 1 (set it to
High)
Key Operation
Channel Next
> > >
Start 4 0 0
> > >
Stop 1 . 4
Measurement
key
Channel Next
>
M/u
>
G/n
441