Connecting Power Meter; Selecting Power Meter; Setting Address Of Gpib Power Meter; Setting Usb Power Meter - Agilent Technologies E5071C Manual

Sensor
7. Measuring Calibration
Data

1. Connecting Power Meter

Connect the GPIB connector on the E4418B (GPIB address: 14) to the
E5071C through USB/GPIB Interface.
From Firmware revision 9.2, E5071C supports USB enabled
•
power sensors. When you connect USB enabled power sensor
for the first time, new hardware wizard runs. For more
information, refer to Setting system controller (USB/GPIB
interface)

2. Selecting Power Meter

Follow the steps to select the power meter
Setting Description
USB/GPIB

Setting Address of GPIB Power Meter

Follow these steps to configure the power meter's GPIB address.
Setting Description
GPIB address of the power meter:
14
You can also set the GPIB address of power meter by pressing
•
System

Setting USB Power Meter

Follow these steps to configure the USB power meter
Setting Description
USB power meter
3. Setting Stimulus Condition
Follow these steps to configure the stimulus conditions:
Setting Description
Executes the measurement of calibration
data.
> Misc Setup > Power Meter Setup > GPIB Address
Key Operation
Key Operation
> Misc Setup > Power
System
Meter Setup > Select Type >
USB/GPIB
Key Operation
> Misc Setup > GPIB Setup
System
> Power Meter Address >
x1
Key Operation
> Misc Setup > Power
System
Meter Setup > USB
Measurement
> >
1 4
447