Agilent Technologies E5071C Manual page 860

Executing the above command will save the measurement data of the
active trace. Note that the data saved using the above command cannot be
recalled from the E5071C.
Saving Measurement Data in Touchstone Format
Measurement data for the active channel can be saved to a file in
touchstone format.
To determine a file type in touchstone file format and specify a port, use
one of the following commands according to the number of ports used:
•
:MMEM:STOR:SNP:TYPE:S1P
•
:MMEM:STOR:SNP:TYPE:S2P
•
:MMEM:STOR:SNP:TYPE:S3P
•
:MMEM:STOR:SNP:TYPE:S4P
To set a data type for files saved in touchstone format, use the following
command:
:MMEM:STOR:SNP:FORM
To save measurement data in touchstone format, use the following
command:
:MMEM:STOR:SNP
Only trace data of frequency sweep can be saved in touchstone
•
format files.Trace data of frequency offset measurement and
power sweep measurement cannot be saved.
Saving Images
Images displayed on the LCD screen can be saved to a file in the bitmap
(.bmp) or portable network graphics (.png) format.
To save the screen image to a file, use the following command:
:MMEM:STOR:IMAG
Executing the above command will save the screen image when the
command is invoked.
This gives different screen image results from those obtained by
•
pressing the
Saving and Recalling Segment Sweep Table
Segment sweep table can be saved in the file with CSV (Comma Separated
Value) format.
To save segment sweep table on a file, use the following command:
:MMEM:STOR:SEGM
Executing the above command will save the segment sweep table for the
active channel.
key on the front panel.
[Capture]
Programming
1087