Front Usb Port; Ground Terminal; Probe Power - Agilent Technologies E5071C Manual

The port to which the DUT is connected. Number of ports depends on the
option. While signals are being output from a test port, the yellow LED
above the test port is lit.
Test Port for options 2D5, 4D5, 2K5 and 4K5
Options
230, 430, 235, 435, 240, 440, 245, 445, 260,
460, 265, 465, 280, 480, 285, 485
2D5, 4D5, 2K5 and 4K5
Do not apply DC voltage or current to the test port. Applying DC
•
voltage or current may lead to device failure. In particular, the
capacitor might remain charged. Connect the measurement sample
(DUT) to the test port (or the test fixture, cables, etc. connected to
the test port) after the analyzer has been completely discharged.
The maximum DC limit of test port is 35V.
The test ports comply with Installation Category I of IEC 61010-1.

12. Front USB Port

Two USB (Universal Serial Bus) ports are provided that can be used for
connecting to ECal (Electronic Calibration) module, USB, Multiport test set
or a printer. Connecting a designated ECal module to this port enables ECal
measurements to be taken. Connecting a compatible printer to this port
enables screen information on the E5071C to be printed. For more on
executing ECal measurements, see Calibration, and for printing, see
Printing Displayed Screen.
The specifications of this port are identical to those of the Rear USB
•
port.

13. Ground Terminal

Connected to the chassis of the E5071C, a ground terminal is provided with
the E5071C. You can connect a banana-type plug to this terminal for
grounding.

14. Probe Power

The E5071C comes with two ports that can be used to provide power to
external probes. See the Data sheet for the voltage and maximum current.
Quick Start
Connector type
50 ohm, N-type,
female
50 ohm, 3.5 mm,
male
29